Jersey Display Cases: Custom Sports Memorabilia Cabinets From the Factory
A signed jersey is a piece of textile, and textiles fail in ways glass and metal do not: they fade under UV, sag on a hanger, and stain where they touch an acidic backing. A jersey display case that ignores this turns a valuable shirt into a faded one within two summers.
What the case has to do
Three requirements drive the build. The garment must hang without stretching at the shoulders, which means a concealed rod or an internal mannequin form rather than pins. The glazing must filter ultraviolet light, because UV is what bleaches dye in a red or navy shirt. And the backing must be acid-free, so the fabric does not yellow where it contacts the board. Everything else — frame finish, depth, lighting — is decided after those three.
Mounting methods
For a single shirt we build a shallow case with a removable hanging bar and a shaped shoulder support, so the jersey holds its shape without a mannequin. For a club displaying several shirts in a row we use a deeper cabinet with a rail system, which lets staff swap a shirt without dismantling the case. Retired numbers and match-worn shirts often need a full torso form; that dictates a depth of at least 200 mm and a door that opens wide enough to lift the form out.
Glazing and light
UV-filtered laminated glass is the default for signed pieces. Where the case sits opposite a window we recommend laminated glass with a low-iron outer pane, which cuts the green cast that ordinary glass adds to white shirts. If the case is lit internally, use LED at 4000 K with the strip set behind a baffle so the light washes the fabric instead of spotting it; heat from older halogen fittings is the second most common cause of damage after sunlight.
Cabinet or frame
A frame suits one shirt on one wall. A cabinet is the right answer for clubs, stadiums, sports bars and memorabilia retailers, because it holds several pieces at consistent spacing, can be locked, and can be extended later along the same wall. We build both, and we build them to the same glazing and backing standard — the difference is depth, door type and how the interior is divided.
Ordering from the factory
Send the shirt dimensions, the wall or room size, how many pieces will be shown, and whether the case needs to be locked. We return a 3D layout of the run, then a quotation per unit. Typical production is 25 to 35 days, and we ship DDP so freight, duty and clearance are one number rather than three.




Comments